Eigenschaften

• 8 configurable inputs/outputs (TTL-level)
  
• Presetable power-on value for outputs
  
• RS-485 serial interface
  
• Protocol: Modbus/RTU
  
• Connects to LED displays, buttons, temperature and humidity sensors
  
• Converts WIEGAND reader interface to RS-485 serial interface
  
• extension module for Barix Barionet

Beschreibung

Barix X8 is I/O to RS-485 Modbus converter for commercial interfacing, control and home automation applications.

Using the industry standard Modbus protocol over 2-wire RS-485 the device can be controlled from any Modbus capable master.

Eight independent configurable inputs/outputs allow the use of the Barix X8 in a wide range of I/O applications:

• General I/O to RS-485 converter (inputs and outputs)
• WIEGAND reader to RS-485 converter (inputs and outputs)
• Up to eight push buttons (inputs) or LED’s for status display
• Local temperature and humidity reading (inputs)

The eight I/O ports support TTL level (5VDC) with limited current range for outputs (supply voltage depending, 24 to 85mA total). For applications with industrial voltage level (10 to 30 VDC) and higher currents (max. 6A total) select the Barix IO12 instead.

Over the RS-485 interface each I/O port can be configured as either an input or an output. Outputs can be preset with a power-on value. I/O ports can be configured to support up to 16 1-wire temperature sensors, one humidity sensor and an access reader supporting the WIEGAND interface (data, tampering alarm, buzzer and LED).

Barix X8 supports Modbus/RTU protocol speeds of 9’600 and 19’200 Bauds, with and without parity.A 4-wire cable (2 bus, 2 power) can be used to connect other Modbus devices in a bus or a star configuration. Up to 31 Barix X8 converters can be directly connected to a Modbus master such as the Barix Barionet and can be increased to up to 250 converters using standard RS-485 repeaters.

Using the Barix Barionet, the Barix X8 can be controlled by a local Basic application (BCL) as well as remotely using TCP, UDP, Modbus/TCP and SNMP. Two mounting brackets with 5mm holes allow mounting on surfaces but can be removed (predetermined braking line) if not used.