AKCP AC Voltage Sensor (ACV00)

The AC voltage detector is used to indicate the presence or absence of line voltage. This is useful, for example to tell when the UPS is running on battery power.

The AC Voltage Detector indicates an ALARM/NORMAL condition in software and also via an LED mounted on the sensor. Voltage detectors can detect the presence or the absence of line voltage. It is designed for use worldwide. There is an SNMP interface for getting the alarm/normal status. SNMP traps are sent when critical conditions occur.

SNMP polling via ?get? is available to retrieve existing status and configuration parameters. The Web browser interface is also available to display the status and configuration parameters.

When an alarm condition is activated the description and location of the fault can be sent via email, page or traps.

AKCP Voltage sensor is specially designed for monitoring AC voltage presence or absence of line voltage up to 250V. It comes with an ALARM/NORMAL indication in the device rmware. You can have up to two voltage sensors per sensorProbe2 and up to 8 in sensorProbe8.

Connect up to 8 Voltage Sensors to each securityProbe, securityProbe 5E base units, or E-sensor8 expansion module RJ-45 sensor ports.

All AKCP Devices comes with an SNMP interface for alarm/normal status, you can set these using the web interface and congure them for sending alerts as SNMP traps, Email and SMS.

Specifications

Measurement Range :

• Detects voltage at 50V AC to 250 VAC

Measurement Indication :

• Alarm or Normal

Communications Cable :

RJ45 jack to sensor using UTP Cat 5 wire

Sensor Type :

• Open/closed contact switch

Power Source :

• Powered by the sensorProbe. No additional power needed

Power Consumption :

• Typical 11.35 mWatt, 2.27mA

Measurement Rate :

• Multiple readings every second
• LED indicator on sensor shows if voltage present
• sensorProbe auto detects the presence of the voltage sensor
• Up to 2 voltage detector per sensorProbe2, up to 8 on the sensorProbe8
• Full autosense including disconnect alarm