HW group Flood detector 1W-UNI 3m
Water detection at a specific point (1D water detection).
- Connects as a RJ11 sensor to Ares / Poseidon2 LAN/GSM monitoring units.
- The sensor can be fully submerged.
- The middle hole facilitates mounting on a wall.
Simple spot water sensor (1D water detection). Water leak detection using four protruding pins on the sensor body.
The attached 3m cable can be directly connected to a RJ11 port of Ares or Poseidon2 monitoring units for water alarm.
The flood sensor can be left lying on the floor (on an electrically insulating surface), or attached to the floor or to a wall. Designed for flood detection, senses water and other electrically conductive liquids.
Applications
- Detection: 1D water detection (at a specific point)
- Interface: 1-Wire UNI (RJ11)
- Cable length: 3m
- Connects to: Poseidon2 (LAN monitoring), Ares (GSM monitoring)
- Power supply: Powered from the 1-Wire UNI bus (RJ11)
- Environment: Indoor or outdoor use
Monitoring the flood detector over LAN
- The water flood sensor connects to the RJ11 connector for 1-Wire UNI sensors.
- Flood detector does not need external power.
- The flood sensor is a spot detector – detects water at a specific point (1D water detection).
GSM water alarm when water is detected
- All three sensors are connected to the T-Box hub for 5 RJ11 sensors.
- The sensors are powered from the Ares internal battery even in case of power supply failure.
- Water sensor detects water at a specific point (on the sensor body).
- 1D detection indicates water detection at a single point.
- The WLD sensing cable that connects to the “WLD Relay” sensor detects water leak along its entire length.
- 2D detection means an alarm when the first drops of water are detected anywhere in an area.
Specifications
Bus | |
Type | 1-Wire UNI |
Supported | HWg-Ares, Poseidon2, Poseidon 2250, 4002 |
Output states | 0 = OK, 1 = flood |
Connector | 1x RJ11 on a 3m cable |
Power | Powered from the 1W-UNI (RJ11) bus |
Power limits | One active port (RJ11 connector of a Poseidon or Ares unit) can power max. 2 “Flood detector 1W-UNI 3m” sensors. To boost the power, use our “1-Wire hub Power” powered hub. |
Max. distance | 60 m (from the Poseidon / Ares unit active port) |
Sampling interval | Sensor status is sampled on the 1W-UNI bus every 1–3 seconds. |
Physical characteristics | |
Operating conditions | –25°C to +85°C (–13°F to +185°F) / 5 to 90 % relative humidity |
Mounting hole | 1x Ø4 [mm] |
Water resistance | IP67 –Sensor can be submerged in water |
Dimensions / mass | 36 x 50 x 22 [mm] / 80 g |
Ordering
Flood detector 1W-UNI 3m
- Water flood sensor – spot detector, 1W-UNI (RJ11) interface. Compatible with Ares and Poseidon2.
Kunden, die diesen Artikel gesehen haben, sahen auch